Re: Lost Host VDS configuration after changing the vlan
my case is similar to mentioned below link, i tried the rectify also no luck .. http://sostechblog.com/2011/06/06/vds-out-of-sync/
View ArticleCan a traffic shaping policy be configured for an entire dvSwitch?
...or only configured at the dvPortGroup level?
View ArticleRe: inter esxi host ipv6 multicast traffic are not seen by the destination VM
Hi, Thank you for looking at the issue.Over the weekend, I managed to test the issue on two other environment. - Current stage environment with problem: Physical DL380 G8 servers Catalyst switches ESXi...
View ArticleRe: Distributed switch - DMZ - Firewall
cehash, thank you for your reply. We will create separate vDS for each network. Regards.
View ArticleRe: Networking Bug in KB 2072694
The issue has now been resolved in a new patch released a few days ago:VMware KB: VMware ESXi 5.1, Patch ESXi510-201402401-BG: Updates esx-base This patch updates the esx-base VIB to resolve the...
View ArticleRe: inter esxi host ipv6 multicast traffic are not seen by the destination VM
- Prod environment Dl380G6 blades with HP Virtual Connect Catalyst switches ESXi 4.1 update 3 Success in inter host ICMPv6 we just purchased DL380 G8 bladesA bit confusing here. I suppose you're...
View ArticleComment Connecter/deconnecter une VM sur un VitualportGroup en Powercli , How...
Bonjour , Hi everybody;Comment déconnecter une VM d'un VirtualPortGroup et la reconnecter sur un autre , en utilisant exclusivement Powercli.How can i disconnet a VM from a VirtualPortGroup and...
View ArticleCan I create an internal or isolated network on VDS that shared across hosts?
We are looking at deploying VDS on our recovery site (for SRM). We have stretched out layer 2 network so hosts on the primary and recovery site can use the same IP addresses, but I am not sure the best...
View ArticleRe: Can I create an internal or isolated network on VDS that shared across...
They won't be able to communicate without a separate VLAN on the upstream physical switch. if you have VCloud suite licensing for vCNS you could create a VXLAN allowing them to communicate, but the...
View Article2 x 1GB & 2 x 10GB NICs - Best Practices
Hi all,We have an install to complete which consists of a Dell M1000e enclosure with Dell M620 hosts which each have 2 x 1GB NICs and 2 x 10GB NICs in them. The SANs are Dell Equallogic PS-M4110's...
View ArticleRe: 2 x 1GB & 2 x 10GB NICs - Best Practices
We have just discovered the answer I think... NPAR!
View ArticleClik here to view.
Re: Can I create an internal or isolated network on VDS that shared across...
Thanks. What I was expecting unfortunately Still, hopefully it won't be too hard to arrange a separate VLAN.
View ArticleClik here to view.
Re: Networking Bug in KB 2072694
Yeah I saw that earlier. Quick fix Good job for vmware. I was already planning rolling out some TSO options, this saves me tons of work.
View ArticleRe: Can a traffic shaping policy be configured for an entire dvSwitch?
Hi, Traffic shaping policy can only be applied on each port or port group level in the distributed switch. However, you can configure it on entire standard vSwitch. Please refers to vSphere Networking...
View ArticleRe: Best Design for 6 x 1Gb NICs
Good thoughts. Thanks for the input. Yes that is right - storage is on the other mezzanine card. I think I came up with one slight improvement. What I did is move backup traffic from mez 2 to mez...
View ArticleRe: inter esxi host ipv6 multicast traffic are not seen by the destination VM
Hi,MKguy wrote: - Prod environment Dl380G6 blades with HP Virtual Connect Catalyst switches ESXi 4.1 update 3 Success in inter host ICMPv6 we just purchased DL380 G8 bladesA bit confusing here. I...
View ArticleRe: inter esxi host ipv6 multicast traffic are not seen by the destination VM
I'm not sure whether this will really solve your specific problem, but it's worth a try to update the NIC firmware and driver. Seems like this is a HP NC 331FLR NIC (DL gen8 default 4-port NIC with...
View ArticleRe: unable to delete a distributed switch
Hi to all. I've the same problem.I moved dvuplink down to unsed, but I unable to remove vds yet. Thanks for all suggestions
View ArticleUnable to Remove vDS from vCenter 5.5
Hi All, I'm trying to remove a distributed switch from the vcenter but it comes up with an error message box: "vDS SW-DCN-C1_C2 port c-40 is used by entity <not-found.> Virtual NIC 4000,...
View Article